Nissan Sentra Owners Manual: Technical and consumer information
- Recommended fluids/lubricants and capacities
- Fuel recommendation
- Engine oil and oil filter recommendations
- Air conditioner system refrigerant and oil recommendations
- Specifications
- When traveling or registering your vehicle in another country
- Vehicle identification
- Vehicle identification number (VIN) plate
- F.M.V.S.S./C.M.V.S.S. certification label
- Emission control information label
- Installing front license plate
- Vehicle loading information
- Towing a trailer
- Uniform tire quality grading
- Emission control system warranty
- Reporting safety defects
- Readiness for inspection/maintenance (I/M) test
- Event Data Recorders (EDR)
- Owner’s Manual/Service Manual order information
Changing wheels and tires
Tire rotation
NISSAN recommends rotating the tires
every 7,500 miles (12,000 km).
See “Flat tire” in the “In case of emergency”
section of this manual for tire replacing
procedures. ...
Recommended fluids/lubricants and capacities
The following are approximate capacities. The actual refill capacities may
be slightly different. When refilling, follow the procedure
described in the “Maintenance and do-it-yourself” section ...
Other materials:
Seat belt warning system
Seat Belt Warning System Does Not Function
1.SEAT BELT WARNING LIGHT
Turn ignition switch ON.
Does the seat belt warning lamp come ON?
YES >> GO TO 2.
NO >> • Check 10A fuse [No. 8, located in the fuse block (J/B)].
Check seat belt buckle switch (driver seat)
Check ha ...
Fuel pressure
Work Procedure
FUEL PRESSURE RELEASE
1.FUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using
CONSULT
Start engine.
After engine stalls, crank it two or three times to release ...
Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final
tightening with grounded and unloaded vehicle
condition, and then check wheel alignment.
Observe the following precautions when disassembling.
Before disassembly, thoroughly clean the outside of the
unit.
...
