Nissan Sentra Service Manual: Front disc brake

Nissan Sentra Service Manual / Brakes / Brake system / Periodic maintenance / Front disc brake

Brake Burnishing

CAUTION:

Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage.
Be careful of vehicle speed. Brakes do not operate firmly/securely until pads and disc rotor are securely seated.
Only perform this procedure under safe road and traffic conditions. Use extreme caution.

Drive the vehicle on straight, flat road.
Depress the brake pedal until the vehicle stops.
Release the brake pedal for a few minutes to allow the brake components to cool.
Repeat steps 1 to 3 until pad and disc rotor are securely seated.

Brake fluid

Drain and Refill CAUTION: Do not spill or splash brake fluid on painted surfaces. Brake fluid may damage paint. If brake fluid is splashed on painted areas, wash it away with water immediate ...

Rear drum brake

Brake Burnishing CAUTION: Burnish contact surfaces between brake drum and brake lining according to the following procedure after refinishing or replacing brake drum, or if a soft pedal occu ...

Other materials:

Wiring diagram
BCM Wiring diagram ...

Basic inspection
Diagnosis and repair workflow Trouble diagnosis flow chart Trouble diagnosis procedure Interview with customer Interview with the customer is important to detect the root cause of can communication system errors and to understand vehicle condition and symptoms for proper trouble diagnosi ...

C1601 Battery power supply
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1601 BATTERY VOLT When a power supply voltage to the EPS control unit is maintained at 17.5 V or more or at less than 9 V continuously for five second or more. ...