Nissan Sentra manuals

Nissan Sentra Service Manual: Periodic maintenance

Rear disc brake
BRAKE PAD BRAKE PAD : Inspection PAD WEAR Check pad thickness from an inspection hole on caliper body. Check using a scale if necessary. Wear limit thickness : Refer to BR-55, "Rear Disc Br ...

Brake pedal
Adjustment BRAKE PEDAL HEIGHT Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation". Disconnect the harness connectors from the brake pedal position switch ...

Other materials:

Hazard switch
Component function check 1.Check hazard switch signal by consult Consult data monitor Turn ignition switch ON. Select hazard sw of bcm (flasher) data monitor item. While operating the hazard switch, check the monitor status. Is the inspection result normal? Yes >> hazard swi ...

P0138 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/ F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. MALFUNCTION A To judge the malfunction ...

Does not stop fully-open or fullyclosed position
Diagnosis procedure 1. Perform initialization procedure Perform initialization procedure. Refer to RF-18, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> Inspection End. NO >> Perform basic ins ...

В© 2014-2026 Copyright www.nisentra.com