Nissan Sentra manuals

Nissan Sentra Owners Manual: Air conditioner operation (if so equipped)

Start the engine, turn the fan control dial to the desired position, and press the  activate the air conditioner. When the  air conditioner button to
activate the air conditioner. When the  air conditioner is on, cooling and dehumidifying functions are added to the heater operation.

The air conditioner cooling function operates only when the engine is running.

Cooling

This mode is used to cool and dehumidify the air.

  1. Press the position. button to the OFF
    position.
  2. Press the button. air flow control
    button.
  3. Turn the fan control dial to the desired position.
  4. Press the indicator light button. The
    indicator light comes on.
  5. Turn the temperature control dial to the desired position.

Dehumidified heating

This mode is used to heat and dehumidify the air.

  1. Press the position. button to the OFF
    position.
  2. Press the button. air flow control
    button.
  3. Turn the fan control dial to the desired position.
  4. Press the indicator light button. The
    indicator light comes on.
  5. Turn the temperature control dial to the desired position.

Dehumidified defogging

This mode is used to defog the windows and dehumidify the air.

  1. Press the button. air flow control
    button.
  2. Turn the fan control dial to the desired position.
  1. Turn the temperature control dial to the desired position.

Operating tips

Heater operation
This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. Press the button to the OFF position for normal heating. ...

Air flow charts
The following charts show the button and dial positions for MAXIMUM AND QUICK heating, cooling or defrosting. The air recirculation button should always be in the OFF position for heating and defr ...

Other materials:

Coil spring
Exploded View Upper rubber seat Coil spring Lower rubber seat Rear suspension beam Front Removal and Installation REMOVAL Set a suitable jack under the rear suspension beam. CAUTION: At this step, the jack must be set only for supporting the removal procedure. For d ...

P1586 G Sensor
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P1586 G Sensor (Gravity Sensor Circuit) When the following diagnosis conditions are satisfied and the detection conditions are satisfi ...

Strg branch line circuit
Diagnosis Procedure 1.Check connector Turn the ignition switch off Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side). Is the inspection result ...

© 2014-2025 Copyright www.nisentra.com