Nissan Sentra B18 (2020-2025) Owner's Manual: Wiper and washer switch
Switch operation

WARNING
In freezing temperatures, windshield washer fluid may freeze on the glass surface and temporarily reduce visibility, which could lead to an accident. Always warm the windshield using the defroster before operating the washer system on your Nissan Sentra.
CAUTION
- Do not operate the windshield washer continuously for more than 30 seconds at a time.
- Do not operate the washer system if the windshield washer fluid reservoir is empty.
- Do not fill the windshield washer fluid reservoir with washer fluid concentrate at full strength. Some methyl alcohol-based washer fluid concentrates may permanently stain the grille if spilled while filling the reservoir.
- Always pre-mix windshield washer fluid concentrates with water to the
manufacturer’s recommended ratio before adding the fluid to the reservoir.
Do not use the windshield washer fluid reservoir itself to mix washer fluid concentrate and water.
NOTE:
If windshield wiper operation is interrupted by snow or ice buildup, the wipers may automatically stop to protect the motor. If this occurs, move the wiper switch to the OFF position and carefully remove any snow or ice from around the wiper arms. After approximately one minute, turn the switch back on to resume normal operation.
The windshield wiper and washer system on the Nissan Sentra operates when the ignition switch is placed in the ON position.
Push the wiper lever downward to operate the windshield wipers at the following speeds:
- Intermittent – intermittent operation can be adjusted by rotating the control
knob toward A (faster) or B (slower). The intermittent wiping speed also varies
automatically based on vehicle speed.
For example, when vehicle speed increases, the intermittent wiping frequency will increase accordingly.
- Low – continuous low-speed wiper operation
- High – continuous high-speed wiper operation
Push the lever upward to position 4 to activate a single wipe (MIST) operation of the windshield wipers.
Pull the lever toward you to position 5 to operate the windshield washer. When the washer is activated, the windshield wipers will also operate automatically several times.
NOTE:
The Wiper with Speed feature may be disabled depending on vehicle configuration.
Other materials:
B1317 Xm Antenna Connection
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection condition
...
U0073-00 Can Comm Circuit
Dtc Description
DTC Description
CAN (Controller Area Network) is a serial
communication line for real time applications. It is an on-Nissan Sentra vehicle
multiplex communication line with high data communication speed and
excellent error detection ability. Modern Nissan Sentra vehi ...
Bcm (body Control Module)
List of Ecu Reference
List of ECU Reference
ECU
Reference
BCM
Values on the Diagnosis Tool
...