Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / U2384 Can Comm Circuit

Nissan Sentra B18 (2020-2025) Service Manual: U2384 Can Comm Circuit

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U2384	CAN comm err (eVTC) [CAN comm err (eVTC)]	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	ECM is not receiving CAN communication signal other than OBD (emission related diagnosis).
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

Harness or connectors (CAN communication line is open or shorted)
Electric intake valve timing control module

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC U2384 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?
YES >>
Proceed to DTC Description.
NO >>
GO TO 2.
PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>
GO OT 3.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON and wait at least 3 seconds.
2. Check 1st trip DTC.
Is DTC U2384 detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO-1>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>
Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC U2384 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?
YES >>
Proceed to DTC Description.
NO >>
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

 U2118 Can Comm Circuit

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2118 CAN comm err (Intelligent Key) Diagnosis c...

 C053c Wheel Speed Sensor

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C053C Wheel speed sensor (Wheel speed sensor gen...

Other materials:

Unit Removal and Installation. Transaxle Assembly
Transaxle Assembly Exploded View Exploded View 1. CVT fluid charging pipe cap 2. CVT fluid charging pipe ...

Power Supply and Ground Circuit
A/c Auto Amp. Diagnosis Procedure Diagnosis Procedure CHECK A/C AUTO AMP. GROUND CIRCUIT FOR OPEN Ignition switch OFF. Disconnect A/C auto amp. connector. ...

Basic Inspection
Diagnosis and Repair Work Flow Work Flow Work Flow OVERALL SEQUENCE DETAILED FLOW INTERVIEW FOR MALFUNCTION It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and ...