Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / U2118 Can Comm Circuit

Nissan Sentra B18 (2020-2025) Service Manual: U2118 Can Comm Circuit

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U2118	CAN comm err (Intelligent Key)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	ECM is not transmitting or receiving CAN communication signal other than OBD (emission related diagnosis)
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

Harness or connectors (CAN communication line is open or shorted)

FAIL-SAFE

Not applicable

Confirmation Procedure

Confirmation Procedure

CHECK DTC PRIORITY

If DTC U2118 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?
YES >>
Perform diagnosis for P0607. Refer to DTC Description.
NO >>
GO TO 2.
PRECONDITIONING

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.

>>
GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON and wait at least 3 seconds.
2. Check 1st trip DTC.
Is DTC U2118 detected?
YES >>
Refer to Diagnosis Procedure.
NO-1 >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>
Confirmation after repair: INSPECTION END

Diagnosis Procedure

Diagnosis Procedure

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

 U1040 Eng Comm Circuit

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1040 ENG COMM CIRCUIT (Engine communication cir...

 U2384 Can Comm Circuit

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2384 CAN comm err (eVTC) [CAN comm err (eVTC)] ...

Other materials:

Removal and Installation. Push-Button Ignition Switch
Push-Button Ignition Switch Removal and Installation Removal and Installation REMOVAL Remove shift selector finisher using the following steps: Remove the CVT shift selector knob. Refer to Removal & Installation. Using a suitable tool, release cli ...

B20bd-12 Battery Current Sensor
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...

C1700-86 Control Unit
Dtc Description DTC Description Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure rep ...