S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: U215b-87 Can Comm Err (ipdm E/r)

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

U215B-87

CAN COMM err (IPDM E/R)

[Controller area network communication error (intelligent power distribution module engine room)]

Diagnosis condition

When ignition switch is ON.

Signal (terminal)

CAN communication signal

Threshold

When a Lost communication with IPDM E/R.

Diagnosis delay time

2 seconds or more

POSSIBLE CAUSE

  • CAN communication line

  • IPDM E/R

  • EPS control unit

FAIL-SAFE

Normal control

Confirmation Procedure

Confirmation Procedure

  1. PRECONDITIONING

    1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    >>

    GO TO 2.

  2. DTC REPRODUCTION PROCEDURE

    1. CONSULT

      1. Ignition switch ON.

      2. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.

    Is DTC “U215B-87” detected?

    YES >>

    Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.

    NO >>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO >>

    Confirmation after repair: Inspection End.

    U2156-87 Can Comm Circuit
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2156-87 CAN COMM err (steering angle sensor...
    Power Supply and Ground Circuit. Diagnosis Procedure
    Diagnosis Procedure Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown: Signal name Fuse No. Capacity Ignition power supply 49 10 A Is the fuse blown? YES...

    Other materials:

    Diagnosis System (air Bag)
    Description Description CAUTION: Never use electrical test equipment on any circuit related to the SRS unless instructed in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors. ...

    Air Pressure Monitor
    Consult Function (bcm - Air Pressure Monitor) CONSULT Function (BCM - AIR PRESSURE MONITOR) Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and ...

    Sonar System. Removal and Installation. Sonar Control Unit. Removal and Installation
    Sonar Control Unit. Removal and Installation Removal and Installation Removal and Installation REMOVAL CAUTION: When replacing the sonar control unit, perform "ADDITIONAL SERVICE WHEN REPLACING SONAR CONTROL UNIT". Refer to Work Procedure. Partially remove the trunk s ...