Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Sonar System :: Dtc/circuit Diagnosis / U214e Can Comm Err (combination Meter)

Nissan Sentra B18 (2020-2025) Service Manual: U214e Can Comm Err (combination Meter)

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U214E–87	CAN comm err (combination meter) [CAN communication error (combination meter)]	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	Communication error
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication system (combination meter)

FAIL-SAFE

Obstacle detection is disabled

Confirmation Procedure

DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 2 seconds or more.
  4. Select “Self Diagnostic Result” mode of “SONAR”.
Is DTC U214E–87 detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC U214E–87 detected?
YES>>
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
NO>>
Inspection End.

 U2148 Mac Comm Error [abs Actuator and Electric Unit (control

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2148–87 CAN comm err (brake control unit)...

 U214f Can Comm Err (bcm)

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U214F–87 CAN comm err (BCM) [CAN communica...

Other materials:

Icc System Cannot Be Set (main Switch Turns On/off)
Diagnosis Procedure Diagnosis Procedure The ICC MAIN switch can be turned ON/OFF, but the ICC system cannot be set even if the SET- switch is pressed. Note: The system cannot be set in the following case. When own Nissan Sentra vehicle is travelling below the speed of ...

Roof. Basic Inspection
Diagnosis and Repair Work Flow. Work Flow Work Flow Work Flow OVERALL SEQUENCE DETAILED FLOW INTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfuncti ...

How to use the remote keyless entry function
The remote keyless entry function on the Nissan Sentra allows you to control all door locks using the Intelligent Key. This convenient system enables locking and unlocking of the doors from a distance of up to approximately 33 ft (10 m) away from the vehicle, depending on surrounding condition ...