Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / U2148-87 Can Comm Err (brake Control Unit)

Nissan Sentra B18 (2020-2025) Service Manual: U2148-87 Can Comm Err (brake Control Unit)

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U2148-87	CAN comm err (brake control unit) [Controller area network communication error (brake control unit)]	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	CAN communication signal
		Threshold	When a Lost communication with ABS actuator and electric unit (control unit).
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication line
ABS actuator and electric unit (control unit)
EPS control unit

FAIL-SAFE

Normal control

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
Is DTC “U2148-87” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

 U2140-87 Can Comm Err (ecm)

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2140-87 CAN comm err (ECM) [Controller area...

 U214f-87 Can Comm Err (bcm)

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U214F-87 CAN comm err (BCM) [Controller area...

Other materials:

B20be-11 Battery Temperature Sensor
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...

Periodic Maintenance
Idle Speed Idle Speed : Periodic Maintenance IDLE SPEED : Periodic Maintenance With CONSULT Check idle speed in “DATA MONITOR” mode of “ENGINE” using CONSULT. Without CONSULT Attach induction type (current detection type) rev counter (A) to loop wire as sho ...

Sonar System. Basic Inspection
Diagnosis and Repair Work Flow. Work Flow Work Flow Work Flow OVERALL SEQUENCE Reference 1: Refer to CONSULT Function. Reference 2: Refer to DTC Index. Reference 3: Refer to Symptom Table. DETAILED FLOW INTERVIEW AND SYMPTO ...