Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / U2140-87 Can Comm Err (ecm)

Nissan Sentra B18 (2020-2025) Service Manual: U2140-87 Can Comm Err (ecm)

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U2140-87	CAN comm err (ECM) [Controller area network communication error (engine control module)]	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	CAN communication signal
		Threshold	When a Lost communication with ECM.
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication line
ECM
EPS control unit

FAIL-SAFE

Normal control

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
Is DTC “U2140-87” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

 U0073-00 Can Comm Circuit

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0073-00 Control module comm bus "A" Off (Co...

 U2148-87 Can Comm Err (brake Control Unit)

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2148-87 CAN comm err (brake control unit) [...

Other materials:

U2118-87 Can Comm Err (intelligent Key)
Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Sentra vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan ...

Idle Start/stop System Inoperative
Diagnosis Procedure Diagnosis Procedure Note: Check the idle start/stop system operation condition. Refer to System Description. CHECK START/STOP PROHIBIT CAUSE With CONSULT Select “Stop/Start prohibit cause data recorder” in “WORK SUPPORT” mode ...

C1714-7b Low Tire Pressure Rr
Dtc Description DTC Description Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure rep ...