Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Type a / Dtc/circuit Diagnosis / U2118-87 Can Comm Circuit

Nissan Sentra B18 (2020-2025) Service Manual: U2118-87 Can Comm Circuit

Dtc Description

DTC Description

CAN (Controller Area Network) is a serial communication system for real time application. It is an on-Nissan Sentra vehicle multiplex communication system with high data communication speed and excellent error detectability. Many electronic control units are equipped onto Nissan Sentra vehicles, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with two communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detected condition
U2118-87	CAN COMM CIRCUIT (CAN communication circuit)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	CAN communication signal
		Threshold	When combination meter is not transmitting or receiving
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning. Refer to Fail-safe.

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “METER/M&A”.
Is DTC U2118-87 detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Select erase “Self Diagnostic Result” mode of "METER/M&A".
  3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC U2118-87 detected again?
YES >>
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
NO >>
Inspection End.

 U1321-55 Configuration Unfinished

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1321–55 Config unfinished (Configuration ...

 Power Supply and Ground Circuit

Combination Meter Diagnosis Procedure Diagnosis Procedure CHECK FUSES Check that the following fuses are not blown: Unit Power source Fuse No. Capacity Combination meter Battery...

Other materials:

Intellignet Key Battery. Component Inspection
Component Inspection Component Inspection CHECK INTELLIGENT KEY BATTERY Check by connecting a resistance (approximately 300 Ω) so that the current value becomes about 10 mA. Refer to Removal and Installation. ...

All Doors Do Not Lock/unlock or Trunk/back Door Do Not Open with Request Switch
Description Description All doors do not lock/unlock using front door request switch or trunk does not open using trunk opener request switch. Note: Before starting diagnosis check that Nissan Sentra vehicle condition is as shown in “Conditions of vehicle”, and check each ...

Cruise Control System. Ascd
Precaution. Precautions Precautions Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner" Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BEL ...