Nissan Sentra B18 (2020-2025) Service Manual: U1321-55 Configuration Unfinished

Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Type a / Dtc/circuit Diagnosis / U1321-55 Configuration Unfinished

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U1321–55	Config unfinished (Configuration unfinished)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	—
		Threshold	Configuration is incomplete
		Diagnosis delay time	—

POSSIBLE CAUSE

The Nissan Sentra vehicle setting of combination meter is incomplete.

FAIL-SAFE

—

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch OFF.
  2. Ignition switch ON.
  3. Select “Self Diagnostic Result” mode of “METER/M&A”.
Is DTC U1321-55 detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM CONFIGURATION OF COMBINATION METER
1. CONSULT
  
  Perform configuration of combination meter. Refer to Work Procedure.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC U1321-55 detected?
YES>>
Replace combination meter. Refer to Removal and Installation.
NO>>
Inspection End.

U2118-87 Can Comm Circuit

Dtc Description DTC Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-Nissan Sentra vehicle multiplex communication system ...

Other materials:

Door Hinge
Removal and Installation Removal and Installation REMOVAL Remove front door assembly. Refer to Removal and Installation. Remove front fender. Refer to Removal and Installation. Remove front door hinge bolts (body side) and front door hinge. INSTALLATION Instal ...

Removal and Installation
Removal and Installation CAUTION: When removing, always use a suitable tool that is made of plastic to prevent damage to the parts. Do not damage the door panel. REMOVAL Using a suitable tool, release pawls and remove ...

B2e4f Bcm Pairing
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...