Nissan Sentra B18 (2020-2025) Service Manual: U1300 Av Communication Circuit
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|---|---|---|---|
|
U1300-01 |
AV communication circuit (AV communication circuit) |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
— |
||
|
Threshold |
— |
||
|
Diagnosis delay time |
— |
||
POSSIBLE CAUSE
-
AV communication circuit
-
AV control unit
-
Combination meter
FAIL-SAFE
AV communication is inoperative.
Dtc Confirmation Procedure
DTC Confirmation Procedure
-
PERFORM DTC CONFIRMATION PROCEDURE
-
CONSULT-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
-
Is DTC U1300–01 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
-
Diagnosis Procedure
Diagnosis Procedure
-
CHECK SELF DIAGNOSTIC RESULT
-
Check if any DTC other than “U1300–01” is detected in “Self diagnostic result” mode of “MULTI AV”.
Is any DTC detected?
YES >>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.
NO >>Replace AV control unit. Refer to Removal and Installation
-
Other materials:
B24b4-02 A/c Control
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
...
Brake System. Basic Inspection
Front Disc Brake Rotor. Inspection
Inspection
Inspection
Check for uneven wear of the disc brake rotor
using a micrometer. Replace the disc brake rotor if the thickness
is below the wear limit. Refer to Removal and Installation.
Thic ...
P1212 Tcs Communication Line
Dtc Description
DTC Description
This CAN communication line is used to control the smooth
engine operation during the TCS operation. Pulse signals are exchanged
between ECM and “ABS actuator and electric unit (control
unit)”.
Be sure to erase the ma ...