Nissan Sentra B18 (2020-2025) Service Manual: Power Supply and Ground Circuit
Diagnosis Procedure
Diagnosis Procedure
-
CHECK FUSE
-
Check that the following fuse is not blown:
Terminal No.
Signal name
Fuse No.
Capacity
19
Battery power supply
40
20 A
Is the fuse blown?
YES >>Replace the blown fuse after repairing the affected circuit.
NO >>GO TO 2.
-
-
CHECK POWER SUPPLY CIRCUIT
-
-
Ignition switch OFF.
-
Disconnect AV control unit connector.
-
Check voltage between AV control unit connector and ground.
AV control unit
(−)
Condition
Voltage
(Approx.)
(+)
Connector
Terminal
M92
19
Ground
Ignition switch: OFF
Battery voltage
-
Is the inspection result normal?
YES >>GO TO 3.
NO >>Repair or replace harness or connectors.
-
-
CHECK GROUND CIRCUIT
-
-
Disconnect AV control unit connector.
-
Check continuity between AV control unit connector and ground.
AV control unit
—
Continuity
Connector
Terminal
M92
20
Ground
Yes
M93
29
-
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
-
Other materials:
Noise, Vibration and Harshness (nvh) Troubleshooting. Nvh Troubleshooting Chart
Nvh Troubleshooting Chart
NVH Troubleshooting Chart
Use the chart below to find the cause of the
symptom. If necessary, repair or replace these parts.
...
Manifold Absolute Pressure Sensor
Component Inspection
Component Inspection
CHECK MANIFOLD ABSOLUTE PRESSURE
(MAP) SENSOR-1
Turn ignition switch OFF.
Start engine and warm it up to normal
operating temperature.
Turn ...
Diagnosis System (intelligent Key Unit)
Consult Function (hands Free Module)
CONSULT Function
(HANDS FREE MODULE)
Intelligent Key unit
Refer to CONSULT Function
(HANDS FREE MODULE).
...