Nissan Sentra B18 (2020-2025) Service Manual: U0079 Control Module Comm Bus G Off
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
U0079–00 |
Control module comm Bus G Off (Control module comm Bus G Off) |
[—] |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
CAN communication signal |
|||
|
Threshold |
Transmit or receive is abnormal |
|||
|
Diagnosis delay time |
2 seconds or more |
|||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
CAN communication does not function.
Confirmation Procedure
Confirmation Procedure
-
PERFORM DTC CONFIRMATION PROCEDURE
-
CONSULT-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result� mode of “MULTI AV�.
-
Check DTC.
-
Is DTC U0079–00 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
-
CONSULT-
Ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
-
Is DTC U0079–00 detected again?
YES >>Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
NO >>Inspection End.
-
Other materials:
Symptom Diagnosis. Rear View Monitor System
Rear View Monitor System
Symptom Table
Symptom Table
REAR VIEW MONITOR SYSTEM
Symptoms
Check items
Probable malfunction
location
...
Clutch Point Learning
Description
Description
TCM memorizes a clutch point (engagement timing), and this enables
accurate control. For work procedure, refer to Work Procedure.
Work Procedure
Work Procedure
CLUTCH POINT LEARNING
With CONSULT
Start the engine.
...
P0136 O2 Sensor 2 Bank 1
Dtc Description
DTC Description
The heated oxygen sensor 2 has a much longer switching time
between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage
capacity of the three way catalyst (manifold) causes the longer switching
time.
MALFUNCTION A
To judge the ...