Nissan Sentra B18 (2020-2025) Service Manual: U1010-49 Control Unit(can)
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|---|---|---|---|
|
U1010-49 |
CONTROL UNIT(CAN) [Control unit (CAN)] |
Diagnosis condition |
Ignition switch ON |
|
Signal (Terminal) |
— |
||
|
Threshold |
Detecting error during the initial diagnosis of CAN controller of A/C auto amp. |
||
|
Diagnosis delay time |
1 seconds or more |
||
POSSIBLE CAUSE
A/C auto amp.
FAIL-SAFE
—
Confirmation Procedure
Confirmation Procedure
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULT-
Ignition switch ON.
-
Select “Self Diagnostic Result� mode of “HVAC�.
-
Check DTC.
-
Is DTC detected?
YES >>Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
REPLACE A/C AUTO AMP.
-
Replace A/C auto amp. Refer to Removal and Installation.
Inspection End.
-
Other materials:
Operation
Switch Name and Function
Switch Name and Function
STEERING SWITCH
The steering switch is located on the steering
wheel.
Transmits the steering switch signal to the
combination meter.
...
Multi Remote Ent
Consult Function (bcm - Multi Remote Ent)
CONSULT Function
(BCM - MULTI REMOTE ENT)
DATA MONITOR
Note:
The following table includes information (items)
inapplicable to this Nissan Sentra vehicle. For information (items) applicable to
this vehicle, refer to CONSULT display items ...
Stop Lamp Switch
Component Inspection
Component Inspection
CHECK STOP LAMP SWITCH 1
Ignition switch OFF.
Disconnect stop lamp switch connector.
Check continuity betwe ...