Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Sonar System :: Dtc/circuit Diagnosis / U0073 Control Module Comm Bus a Off

Nissan Sentra B18 (2020-2025) Service Manual: U0073 Control Module Comm Bus a Off

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U0073–00	Control module comm Bus A Off (Control module comm bus A off)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	Communication error
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

Obstacle detection is disabled

Confirmation Procedure

DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 2 seconds or more.
  4. Select “Self Diagnostic Result” mode of “SONAR”.
Is DTC U0073–00 detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC U0073–00 detected?
YES >>
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
NO >>
Inspection End.

 B273b Rear Sensor Power

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B273B–11 REAR SENSOR POWER (Rear sensor po...

 U0075 Control Module Comm Bus C Off

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0075–00 Control module comm Bus C Off (Co...

Other materials:

U2148-87 Can Comm Err (brake Control Unit)
Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Sentra vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan ...

Ascd Steering Switch
Component Inspection Component Inspection CHECK ASCD STEERING SWITCH Turn ignition switch OFF. Disconnect combination switch (spiral cable) harness connector. Check the resistance between ...

Clutch Point Learning
Description Description TCM memorizes a clutch point (engagement timing), and this enables accurate control. For work procedure, refer to Work Procedure. Work Procedure Work Procedure CLUTCH POINT LEARNING With CONSULT Start the engine. ...