Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Sonar System :: Dtc/circuit Diagnosis / U0075 Control Module Comm Bus C Off

Nissan Sentra B18 (2020-2025) Service Manual: U0075 Control Module Comm Bus C Off

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U0075–00	Control module comm Bus C Off (Control module comm bus C off)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	Communication error
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

Obstacle detection is disabled

Confirmation Procedure

DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 2 seconds or more.
  4. Select “Self Diagnostic Result” mode of “SONAR”.
Is DTC U0075–00 detected?
YES>>
Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC U0075–00 detected?
YES>>
Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
NO>>
Inspection End.

 U0073 Control Module Comm Bus a Off

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0073–00 Control module comm Bus A Off (Co...

 U1000 Can Comm Circuit

Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Sentra vehicle multiplex c...

Other materials:

Fuel Rail Pressure Sensor
Component Inspection Component Inspection CHECK FUEL RAIL PRESSURE (FRP) SENSOR With CONSULT Turn ignition switch OFF. Reconnect harness connector disconnected. Start engine a ...

Ecu Diagnosis Information
A/c Auto Amp. Values on the Diagnosis Tool Values on the Diagnosis Tool Note: The following table includes information (items) inapplicable to this Nissan Sentra vehicle: For information (items) applicable to this vehicle, refer to CONSULT display items. ...

Evap Control System Pressure Sensor
Component Inspection Component Inspection CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR Turn ignition switch OFF. Remove EVAP control system pressure sensor with its harness connector connected from EV ...