Nissan Sentra B18 (2020-2025) Service Manual: Tail Lamp
Component Inspection
Component Inspection
-
CHECK TAIL LAMP
-
-
Ignition switch OFF.
-
Disconnect each rear combination lamp connector.
-
Check continuity between each rear combination lamp terminals.
Body side Rear combination lamp (body side)
Continuity
Terminals
2
4
Yes
Trunk lid side Rear combination lamp (trunk lid side)
Continuity
Terminals
1
4
Yes
-
Is the inspection result normal?
YES>>GO TO 2.
NO>>Rear combination lamp (body side): Replace corresponding rear combination lamp (body side) bulb. Refer to Bulb Replacement.
NO>>Rear combination lamp (trunk lid side): Replace corresponding rear combination lamp (trunk lid side) bulb. Refer to Bulb Replacement.
-
-
CHECK TAIL LAMP BULB SOCKET AND HARNESS
-
-
Remove tail lamp bulb.
-
Check continuity between each rear combination lamp terminals.
Body side Rear combination lamp (body side)
Continuity
Terminals
2
4
No
Trunk lid side Rear combination lamp (trunk lid side)
Continuity
Terminals
1
4
No
-
Is the inspection result normal?
YES >>Inspection End.
NO >>Repair or replace the each rear combination lamp bulb socket or harness.
-
Other materials:
P1568 Icc Function
Dtc Description
DTC Description
DTC DETECTION LOGIC
ECM detects a difference between signals from ADAS control unit is
out of specified range.
DTC
CONSULT screen terms
(Tro ...
C1712-7a Low Tire Pressure Fr
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure rep ...
P1588-00 Decel G Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
conditi ...