Nissan Sentra B18 (2020-2025) Owner's Manual: System malfunction

If the Intelligent Forward Collision Warning (I-FCW) system on the Nissan Sentra malfunctions, the system will automatically deactivate. A warning chime will sound, the Automatic Emergency Braking (AEB) with Pedestrian Detection warning light (orange) will illuminate, and the warning message [Malfunction] will be displayed in the vehicle information display to alert the driver.

Action to take

If the warning light (orange) illuminates, safely stop the Nissan Sentra in an appropriate location, turn the engine off, and then restart the engine. If the warning light continues to remain illuminated after restarting, have the I-FCW system inspected. It is recommended that you visit an authorized NISSAN dealer for proper diagnosis and service.

System maintenance

The radar sensor A for the I-FCW system is located on the front of the Nissan Sentra.

To ensure reliable operation of the Intelligent Forward Collision Warning system, observe the following maintenance guidelines:

• Always keep the front bumper and emblem sensor area clean and free of dirt, snow, or debris.
• Do not strike, impact, or otherwise damage the area surrounding the sensor.
• Do not attach stickers, films, or similar materials to the front bumper near the sensor, as this may interfere with system operation or cause malfunction.
• Do not install metallic accessories near the sensor area (such as brush guards), which may block radar signals and lead to system failure.
• Do not modify, remove, or repaint the front bumper. Before performing any customization or repairs to the front bumper, it is recommended that you consult an authorized NISSAN dealer.

Radio frequency statement

For USA

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

FCC Warning

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

For Canada

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference received, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.

L'exploitation est autorisée aux deux conditions suivantes:

1. L'appareil ne doit pas produire de brouillage, et

2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Radio frequency radiation exposure information:

This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 30 cm between the radiator and your body.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé.

Cet équipement doit être installé et utilisé avec un minimum de 30 cm de distance entre la source de rayonnement et votre corps.

FCC Notice

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

© 2014-2026 Copyright www.nisentra.com