Nissan Sentra B18 (2020-2025) Service Manual: Stop Lamp
Component Inspection
Component Inspection
-
CHECK STOP LAMP 1
-
-
Ignition switch OFF.
-
Disconnect rear combination lamp (body side) connector and high-mounted stop lamp connector.
-
Check continuity between each stop lamp terminal.
Stop lamp Rear combination lamp (body side)
Continuity
Terminals
3
4
Yes
High-mounted stop lamp High-mounted stop lamp
Continuity
Terminals
1
2
Yes
-
Is the inspection result normal?
YES>>GO TO 2.
NO >>Rear combination lamp (body side): Replace corresponding rear combination lamp (body side) bulb. Refer to Bulb Replacement.
NO >>High-mounted stop lamp: Replace high-mounted stop lamp. Refer to Removal and Installation.
-
-
CHECK STOP LAMP 2
-
-
Remove stop lamp bulb.
-
Check continuity between rear combination lamp (body side) terminals.
Rear combination lamp (body side)
Continuity
Terminals
3
4
No
-
Is the inspection result normal?
YES >>Inspection End.
NO >>Repair or replace rear combination lamp (body side) lamp bulb socket or harness.
-
Other materials:
Ecu Diagnosis Information. Adas Control Unit 2
Adas Control Unit 2
Values on the Diagnosis Tool
Values on the Diagnosis Tool
Note:
The following table includes information (items)
inapplicable to this Nissan Sentra vehicle. For information (items) applicable to this
vehicle, refer to CONSULT display items.
...
Symptom Diagnosis. Overheating Cause Analysis
Overheating Cause Analysis
Diagnosis Chart by Symptom
Diagnosis Chart by Symptom
Symptom
Inspection item
Cooling system
...
NISSAN Intelligent Key
WARNING
Radio waves may adversely affect electronic medical equipment. Drivers
or passengers who use a pacemaker or similar medical device should consult the
device manufacturer regarding possible effects before using the NISSAN Intelligent
Key in the Nissan Sentra.
The Intelligent Ke ...