Nissan Sentra B18 (2020-2025) Service Manual: Seat Belt Height Adjuster
Removal and Installation
REMOVAL
Remove center pillar upper finisher. Refer to Removal and Installation.
Remove
bolts (A) and seat belt height adjuster (1) from Nissan Sentra vehicle. 
Note: 
LH shown, RH similar.
|
|
: Front |
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Make sure that the seat belt height adjuster is locked in the lowest position and is aligned with the center pillar upper finisher opening during installation.
-
Tighten the D-ring anchor bolt and seat belt height adjuster bolts to specification. Refer to Exploded View.
-
Make sure both the D-ring anchor and seat belt height adjuster operate freely.
-
Always perform an inspection after repair to make sure the system is functioning within specifications. Refer to Inspection.
Front Seat Belt Retractor
Removal and Installation
Removal and Installation
REMOVAL
Warning:
Before servicing the SRS, place the ignition
switch in the OFF position, disconnect both batt ...
Front Seat Belt Buckle
Removal and Installation
Removal and Installation
REMOVAL
Warning:
Before servicing the SRS, place the ignition
switch in the OFF position, disconnect both batt ...
Other materials:
Rear disc brake
Brake Burnishing
CAUTION:
Burnish contact surfaces between brake pads and disc rotor
according to the following procedure
after refinishing the disc rotor, replacing brake pads or if a soft pedal
occurs at very low mileage.
Be careful of vehicle speed. Brakes do not operate firmly/sec ...
Seat Belt Warning Lamp System
System Description
System Description
SYSTEM DIAGRAM
System Description
The seat belt warning lamp (1) will remind the
driver if the driver or front passenger seat belt should be
buckled. The system works in conjunction with the occupant
classification system. Refer to System ...
Service equipment
RECOVERY/RECYCLING RECHARGING EQUIPMENT
Be certain to follow the manufacturer’s instructions for machine operation
and machine maintenance. Do not
introduce any refrigerant other than that specified into the machine.
ELECTRICAL LEAK DETECTOR
Be certain to follow the manufacturer’s ...
