Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Wheel alignment
Inspection PRELIMINARY INSPECTION WARNING: Always adjust the wheel alignment with the vehicle on a flat surface. NOTE: If the wheel alignment is out of specification, inspect and replace any d ...

Front coil spring and strut
Exploded View Piston rod lock nut Strut mount insulator Strut mount bearing Bound bumper Coil spring Lower rubber seat Strut Steering knuckle Front Removal and Installation ...

Other materials:

Work Flow
STEP DESCRIPTION STEP 1 Get detailed information about the conditions and the environment when the incident occurred. The following are key pieces of information required to make a good analysis: WHAT Vehicle Model, Engine, Transmission/Transaxle and ...

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to lan-7, "can communication system : system description". Dtc logic Dtc detection logic Note: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symp ...

Compression pressure
Inspection Warm up the engine to full operating temperature. Release fuel pressure. Refer to EC-143, "Work Procedure". Remove ignition coil and spark plug from each cylinder. Refer to EM-46, "Exploded View". Connect engine tachometer (not required in use of CONSULT). ...

В© 2014-2026 Copyright www.nisentra.com