Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Disconnect battery. Refer to Battery Disconnect.
CAUTION:
To prevent damage to the parts, disconnect the battery negative terminal first.
Disconnect the harness connector from battery current sensor.
Remove the nut and battery current sensor from negative terminal.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Perform "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL". Refer to Special Repair Requirement.
Exploded View
Exploded View
1.
Battery current sensor
2.
...
Other materials:
P0500 Vss
Dtc Description
DTC Description
ECM receives vehicle speed signals from two different paths via
CAN communication line: One is from the ABS actuator and electric unit (control
unit) via the combination unit and the other is from TCM.
DTC DETECTION LOGIC
...
P0706 Transmission range sensor A
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0706
T/M RANGE SENSOR A
(Transmission Range Sensor
A Circuit Range/Performance)
All range signals stay OFF continuously for 30
sec ...
Compression Pressure
Inspection
Inspection
Warm up
engine to full operating temperature. Stop engine.
Release the
fuel pressure. Refer to Work Procedure.
Remove the
fuel pump fuse from IPDM E/R to avoid fuel injection during
measurement.
Remove
ignition coil and spark plug from each ...
