Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Warning:
-
Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
-
Do not use air tools or electric tools for servicing.
Remove the front door finisher. Refer to Removal and Installation.
Remove the vapor barrier.
CAUTION:
Use care to not damage or tear vapor barrier during removal.
Temporarily reconnect the main power window and door lock/unlock switch (LH door) or power window and door lock/unlock switch (RH door) to raise/lower the door glass until the door glass bolts can be seen through the access holes.
Remove the
front door regulator to glass bolts (A).
While
holding the front door glass, raise it at the rear end to pull the
front door glass out of the sash toward the outside of the
door.
INSTALLATION
Installation is in the reverse order of removal.
FRONT DOOR GLASS INSPECTION AFTER INSTALLATION
-
Check that the door glass is securely set into the glass run groove.
-
Lower the door glass slightly [approximately 10 to 20 mm (0.4 to 0.8 in)] and check that the clearance to the sash is parallel. If the clearance between the door glass and sash is not parallel, loosen the regulator bolts, guide rail bolts, and door glass and guide rail bolts to correct the glass position.
Exploded View
Exploded View
1.
Door glass rubber
run
2.
...
Inspection and Adjustment
Inspection and Adjustment
SYSTEM INITIALIZATION (IF NECESSARY)
If any of
the following occur, system initialization must be
performed.
Electric power supply to power windo ...
Other materials:
Door Mirror Turn Signal Lamp
Exploded View
Exploded View
1.
Door mirror assembly
2.
Door mirror base cover
3.
...
Door lock and unlock switch
Component function check
1.Check function
Select door lock of bcm using consult.
Select cdl lock sw, cdl unlock sw in data monitor mode.
Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Main power windo ...
P0606 ECM
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0606
CONTROL MODULE
(Control module processor)
Malfunction in ECM processor.
ECM
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONIN ...
