Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Remove rear suspension member. Refer to Removal and Installation.
Remove the front and rear lower link nut and bolt from the rear suspension member using power tool.
Remove the front and rear lower link nut and bolt from the rear knuckle using power tool.
Remove the front lower link and rear lower link as an assembly.
Remove lower rear suspension link bolts.
Separate front lower link and rear lower link.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not reuse the front and rear lower link nuts.
-
Perform the final tightening of the parts under unladen conditions with the tires on the ground.
-
Check the wheel alignment. Refer to Wheel Alignment (Unladen*1).
-
Adjust the neutral position of the steering angle sensor. Refer to Description.
Exploded View
Exploded View
With Drum Brake
1.
Rear suspension member
...
Rear Stabilizer
...
Other materials:
Dtc Confirmation Procedure
DTC Confirmation Procedure
DTC CONFIRMATION
CONSULT
Ignition switch ON and wait for 2 seconds or
more.
Select “Self Diagnostic Result” mode
...
P1650 Starter motor relay 2
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. ECM transmits
a control signal to IPDM E/R via BCM by CAN communication.
Under normal conditions, ECM controls and maintains the starter relay in OFF
state during following condition:
...
Headlamp (hi)
Component Inspection
Component Inspection
CHECK HEADLAMP (HI) 1
Ignition switch OFF.
Disconnect front combination lamp connector.
Check continuity be ...
