Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
If necessary, remove instrument lower panel LH. Refer to Removal and Installation.
Using a
suitable tool, release clutch master cylinder rod end (A) from
clutch pedal. 
Remove bolts (B) from clutch pedal (1).
Using a suitable tool, release the wiring harness retainers from studs.
Remove nuts
(A) and (B) from clutch pedal assembly (1). 
Remove clutch pedal assembly.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After applying recommended grease, press clutch master cylinder rod end into clutch pedal until it stops
Exploded View
Exploded View
1.
Clutch pedal
2.
...
Inspection and Adjustment
Inspection and Adjustment
INSPECTION AFTER REMOVAL
Check
clutch pedal for bend, damage, or a cracked weld. If bend, damage,
or a cracked weld is found, replace clutch pedal.
Check ped ...
Other materials:
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
try the following solutions.
Where the solutions are listed by number, try
each solution in turn, starting with number 1, until
the problem is resolved.
Symptom
Solution
...
Front manual seat adjustment
Forward and backward
Pull the center of the bar up and hold it while you
slide the seat forward or backward to the desired
position. Release the bar to lock the seat in
position.
Reclining
To recline the seatback, pull the lever up and lean
back. To bring the seatback forward, pull the ...
Precautions
Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as
“AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along wit ...
