KV10111100

(NI-37228)

Seal cutter

Removing oil pan (upper and lower) etc.

KV10112100

(BT-8653-A)

Angle wrench

Tightening bolts for main bearing cap, cylinder head, etc.

KV101197S0

(NI-50364)

Injector seal drift set

1. KV10119730

   ( — )

   Seal installer

2. KV10119710

   ( — )

   Drift

3. KV10119720

   ( — )

   Seal guide

Installing fuel injector seal

 — 

(NI-48891)

Spark plug wrench

Removing and installing spark plug

 — 

(NI-52553)

Cam cover seal installer

Installing camshaft sprocket (INT) oil seal

KV38107900

(NI-52469-1)

Differential side oil seal protector

Installing drive shaft

A: 32 mm (1.26 in) dia

B: Minimum 23 mm (0.91 in)

(NI-52982)

Lock nut chisel (Cape chisel)

Removing wheel hub lock nut

( — )

Pulley holder

Crankshaft pulley removing and installing

( — )

Valve spring compressor

Attachment

Adapter

Disassembling and assembling valve mechanism

Part (1) is a component of KV10116200, but Part (2) is not so.

( — )

Valve oil seal puller

Removing valve oil seal

( — )

Valve oil seal drift

Installing valve oil seal

Use side A.

a: 20 (0.79) dia. d: 8 (0.31) dia.

b: 13 (0.51) dia. e: 10.7 (0.421)

c: 10.3 (0.406) dia. f: 5 (0.20)

Unit: mm (in)

( — )

Piston ring compressor

Installing piston assembly into cylinder bore

( — )

Pulley puller

Removing crankshaft pulley

( — )

Heated oxygen sensor wrench

Loosening or tightening heated oxygen sensor 1

For 22 mm (0.87 in) width hexagon nut

( — )

Valve seat cutter set

Finishing valve seat dimensions

( — )

Piston ring expander

Removing and installing piston ring

( — )

Valve guide drift

Removing and installing valve guide

( — )

Valve guide reamer

1: Reaming valve guide inner hole

2: Reaming hole for oversize valve guide

d1: 6.0 mm (0.236 in) dia.

d2: 10.2 mm (0.402 in) dia.

( — )

Manual lift table caddy

Removing and installing engine

( — )

Tube presser

Pressing the tube of liquid gasket

( — )

Engine stand

Engine overhaul

( — )

Drift

Installing front oil seal

a: φ57.0 mm (2.244 in).

b: φ45.0 mm (1.772 in).

( — )

Drift

Installing rear oil seal

a: φ115.0 mm (4.528 in).

b: φ90.0 mm (3.543 in).

( — )

Stick

Installing rear oil seal

a: φ18.0 mm (0.709 in).

( — )

Compression gauge set

Compression pressure

1: Compression gauge

2: Adapter

( — )

Lock nut crimp punch (Cold chisel)

Installing wheel hub lock nut

a: 5 mm (0.20 in)

b: 7 mm (0.28 in)