Nissan Sentra B18 (2020-2025) Service Manual: Power Outlet :: Removal and Installation
Front Console Power Socket. Removal and Installation. Removal and Installation
Removal and Installation
Removal
Remove the CVT/MT shift selector finisher. Refer to Exploded View.
Disconnect
the harness connector (A) from the front console power socket
(1).
Using a
suitable tool, release the front console power socket pawls from
the back of the console finisher assembly and remove.
|
|
: Pawl |
Installation
Installation is in the reverse order of removal.
Note:
Make sure to align the tab with the square notched area during installation.
Rear Usb Charge Port. Removal and Installation. Removal and Installation
Removal and Installation
REMOVAL
Using a
suitable tool, release clips from center console rear
finisher.
|
|
: Metal clip |
Disconnect harness connectors and remove center console rear finisher.
Remove
screws (A) and rear USB charge port (1) from center console rear
finisher. 
INSTALLATION
Installation is in the reverse order of removal.
Other materials:
Seat Heater Lh (back)
Component Function Check
Component Function
Check
CHECK FUNCTION
Check that the seat heater LH (back) warms to the
preset temperature when operating the heated seat switch LH to HIGH
and LOW.
Is the inspection ...
U0073 Control Module Comm Bus a Off
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection condition
...
C053c Wheel Speed Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...

