Nissan Sentra B18 (2020-2025) Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f15a / Dtc/circuit Diagnosis / P271e-00 Wheel Torque Calculation Signal

Nissan Sentra B18 (2020-2025) Service Manual: P271e-00 Wheel Torque Calculation Signal

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC		CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P271E	00	Wheel torque calculation signal	1	Diagnosis condition	When the ignition switch is ON
				Signal	—
				Threshold	Diagnosis is permitted when all of the following conditions are satisfied: a) Transmission gear ratio: Less than "Estimated gear ratio/1.25" b) Select solenoid valve monitor current: Less than 900 mA
				Diagnosis delay time	50 seconds
			2	Diagnosis condition	When the ignition switch is ON
				Signal	—
				Threshold	Friction torque calculation value: 24.0 Nm or more
				Diagnosis delay time	5 seconds
			3	Diagnosis condition	When the ignition switch is ON
				Signal	—
				Threshold	Mechanical oil pump torque: 23.9 Nm or more
				Diagnosis delay time	5 seconds
			4	Diagnosis condition	When the ignition switch is ON
				Signal	—
				Threshold	Diagnosis is permitted when all of the following conditions are satisfied: a) Torque converter torque ratio: Less than "Estimated torque converter torque ratio/1.25" b) Select solenoid valve monitor current: Less than 900 mA
				Diagnosis delay time	50 seconds

POSSIBLE CAUSE

TCM

FAIL-SAFE

Not changed from normal driving

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

When DTC "P271E-00" is displayed together with "P0793-00" or "P2808-00", diagnose first the "P0793-00" or "P2808-00".

Is "P0793-00" or "P2808-00" detected?
>>
Perform diagnosis of "P0793-00" or "P2808-00". Refer to DTC Index.
NO >>
GO TO 2.
PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V.

>>
GO TO 3.

CHECK DTC DETECTION

With CONSULT

Start the engine.

Drive the Nissan Sentra vehicle and maintain the following conditions for 60 seconds or more.

Shift position	: "D" position
Nissan Sentra Vehicle speed	: 40 km/h (25 MPH) or more

CAUTION:

Be careful of the driving speed.

Stop the Nissan Sentra vehicle.
Check the DTC.

Is "P271E-00" detected?

YES >>

Go to DTC Diagnosis Procedure.

NO >>

INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

REPLACE TCM

Replace TCM. Refer to Removal and Installation.

>>
WORK END

 P1ae0-61 Range Misdisplay

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1AE0 61 Range misdisplay (Range Misdisplay) Dia...

 P2766-00 Input Speed Sensor B

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2766 00 Input/Turbine shaft speed sensor B (Inp...

Other materials:

Front Regulator
Exploded View Exploded View 1. Door glass rubber run 2. Front door glass front run ...

Body Sealing
Description Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffecte ...

Abs Branch Line Circuit (vehicle Can Communication 1 Circuit)
Diagnosis Procedure Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of ...