Nissan Sentra B18 (2020-2025) Service Manual: P2118 Throttle Control Motor
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|
P2118 |
ETC MOT-B1 (Throttle actuator control motor current range/performance) |
Diagnosis condition |
Engine running at idle |
|
Signal (terminal) |
Throttle control motor signal |
||
|
Threshold |
ECM detects short in throttle control motor signal circuit |
||
|
Diagnosis delay time |
— |
||
POSSIBLE CAUSE
-
Harness or connectors (Throttle control motor circuit is shorted.)
-
Electric throttle control actuator (Throttle control motor)
FAIL-SAFE
Engine Control System
|
Engine operating condition in fail-safe mode |
||
|---|---|---|
|
Fail safe mode |
Nissan Sentra Vehicle behavior |
|
|
Device fix mode |
|
|
|
Others |
ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening (approx. 5 degrees) by the return spring. |
|
Idle Start/Stop System
When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited.
When ECM detects error while operating the idle start/stop system, ECM restarts the engine.
Confirmation Procedure
Confirmation Procedure
-
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
-
-
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON and wait at least 2 seconds.
-
Start engine and let it idle for 5 seconds.
-
Check DTC.
Is DTC detected?
YES >>Refer to DTC Diagnosis Procedure.
NO-1 >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>Confirmation after repair: INSPECTION END
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
CHECK THROTTLE CONTROL MOTOR OUTPUT SIGNAL CIRCUIT
-
Turn ignition switch OFF.
-
Disconnect electric throttle control actuator harness connector.
-
Disconnect ECM harness connector.
-
Check the continuity between electric throttle control actuator harness connector and ECM harness connector.
Electric throttle control actuator
ECM
Continuity
Connector
Terminal
Connector
Terminal
F7
5
F25
129
Existed
130
Not existed
6
129
Not existed
130
Existed
-
Also check harness for short to ground and to power.
Is the inspection result normal?
YES >>GO TO 2.
NO >>Repair or replace malfunctioning part.
-
-
CHECK THROTTLE CONTROL MOTOR
Check the throttle control motor. Refer to Component Inspection.
Is the inspection result normal?
YES >>INSPECTION END
NO >>Replace electric throttle control actuator. Refer to Removal and Installation.
Other materials:
B0012-55 Active Vent
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen items
(Trouble diagnosis
content)
DTC Detection Condition
...
Abbreviations. Abbreviation List
Abbreviation List
Abbreviation
List
The following ABBREVIATIONS are
used:
A
ABBREVIATION
DESCRIPTION
A/C
Air conditione ...
B24b0-14 Front Heated Seat Relay Lh (hi)
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis name)
DTC detection condition
...