Nissan Sentra B18 (2020-2025) Service Manual: U1112-24 Deceleration Request Signal
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|||
|
U1112 |
24 |
DECELERATION REQUEST SIGNAL (Deceleration Request Signal) |
1 |
Diagnosis condition |
Accelerator pedal opening ≥ 4 deg |
|
Signal |
CAN communication signal |
||||
|
Threshold |
TCM is unable to receive the CAN communications signal from chassis control module |
||||
|
Diagnosis delay time |
2 seconds |
||||
|
2 |
Diagnosis condition |
Nissan Sentra Vehicle speed ≤ 10 km/h (6 MPH) |
|||
|
Signal |
CAN communication signal |
||||
|
Threshold |
TCM is unable to receive the CAN communications signal from chassis control module |
||||
|
Diagnosis delay time |
10 seconds |
||||
POSSIBLE CAUSE
-
Harness or connector (CAN communication line is error)
-
Chassis control module
-
TCM
FAIL-SAFE
Not changed from normal driving
DTC CONFIRMATION PROCEDURE
-
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V.
>>GO TO 2.
-
CHECK DTC DETECTION
With CONSULT-
Start the engine and wait for at least 10 seconds.
-
Drive the Nissan Sentra vehicle at 10 km/h (6 MPH) for at least 10 seconds.
-
Stop the vehicle.
-
Check the DTC.
Is "U1112-24" detected?
YES >>Go to Diagnosis Procedure.
NO >>INSPECTION END
-
Diagnosis Procedure
Diagnosis Procedure
For the diagnosis procedure, refer to Trouble Diagnosis Flow Chart.
Other materials:
Low Tire Pressure Warning Lamp Does Not Turn Off
Symptom Description
Symptom Description
The low tire pressure warning lamp does not turn
OFF after several seconds is passed after the engine starts.
Diagnosis Procedure
Diagnosis Procedure
CHECK TIRE PRESSURE
Ignition switch ...
Knock Sensor
Component Inspection
Component Inspection
CHECK KNOCK SENSOR
Turn ignition switch OFF.
Disconnect knock sensor harness
connector.
Check resistance between knock sensor
terminals ...
Remote Keyless Entry Function
System Diagram
System Diagram
System Description
System Description
The Intelligent Key has the same functions as the
remote control entry system. Therefore, it can be used in the same
manner as the remote controller by operating the door lock/unlock
button.
OPERATION
Re ...