Nissan Sentra B18 (2020-2025) Service Manual: P0604-00 Control Module Ram
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|
P0604 |
00 |
CONTROL MODULE RAM [Internal Control Module Read Access Memory (RAM) Error] |
Diagnosis condition |
When the ignition switch is ON |
|
Signal |
— |
|||
|
Threshold |
TCM RAM area sum parity check detects malfunction in RAM. |
|||
|
Diagnosis delay time |
— |
|||
POSSIBLE CAUSE
TCM (RAM)
FAIL-SAFE
-
Selector shock is large
-
Start is slow
-
Acceleration is slow
-
Lock-up is not performed
-
Stop/start system prohibited
DTC CONFIRMATION PROCEDURE
-
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V.
>>GO TO 2.
-
CHECK DTC DETECTION
-
Ignition switch ON.
-
Check the DTC.
Is "P0604-00" detected?
YES >>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
REPLACE TCM
Replace TCM. Refer to Removal and Installation.
>>WORK END
Other materials:
Dtc/circuit Diagnosis. Position Switch
Position Switch
Back-Up Lamp Switch
Component Inspection
Component Inspection
CHECK BACK-UP LAMP SWITCH
Disconnect position switch harness connector.
Refer to Removal and Installation.
...
C161a-83 Abs System
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
...
Sonar System. Removal and Installation. Sonar Control Unit. Removal and Installation
Sonar Control Unit. Removal and Installation
Removal and Installation
Removal and Installation
REMOVAL
CAUTION:
When replacing the sonar control unit, perform
"ADDITIONAL SERVICE WHEN REPLACING SONAR CONTROL UNIT". Refer to Work Procedure.
Partially
remove the trunk s ...