Dtc Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|
P10C0 |
Internal control module fuel injector (Internal control module fuel injector) |
Diagnosis condition |
Battery voltage: 11 V or more |
|
Signal (terminal) |
— |
||
|
Threshold |
Direct injector driver unit is malfunctioning. |
||
|
Diagnosis delay time |
— |
||
POSSIBLE CAUSE
Harness or connectors
Direct fuel injector circuit is open
Battery power supply
ECM (Direct injector driver unit)
FAIL-SAFE
Engine Control System
|
Engine operating condition in fail-safe mode |
||
|---|---|---|
|
Fail safe mode |
Nissan Sentra Vehicle behavior |
|
|
Traveling control mode |
Accelerator angle variation control |
ECM controls the accelerator pedal depression speed to make it slower than actual speed. This causes a drop in accelerating performance and encourages the driver to repair malfunction. Note:
ECM does not control the accelerator pedal releasing speed. |
|
Device fix mode |
|
|
|
Combustion control mode |
Stratified charge combustion control at starting |
No stratified charge combustion at starting (cold start). |
Idle Start/Stop System
When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited.
When ECM detects error while operating the idle start/stop system, ECM restarts the engine.
Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 12 - 15 V at idle.
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
Start engine and let it idle for at least 10 seconds.
Check 1st trip DTC.
Is 1st trip DTC detected?
YES >>Refer to DTC Diagnosis Procedure.
NO-1 >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>Confirmation after repair: INSPECTION END
Dtc Diagnosis Procedure
CHECK DIRECT FUEL INJECTOR
Check direct fuel injector. Refer to Component Function Check.
Is inspection result normal?
YES >>GO TO 2.
NO >>Repair or replace error-detected parts.
PERFORM DTC CONFIRMATION PROCEDURE
Turn ignition switch ON.
Erase DTC.
Perform DTC confirmation procedure again. Refer to Component Function Check.
Check 1st trip DTC.
Is the DTC displayed again?
YES >>Replace ECM. Refer to ECM : Removal & Installation.
NO >>INSPECTION END
P0850 Pnp Switch
P10c1 Internal Control Module Fuel InjectorFront door finisher
Exploded View
Front door panel
Front door finisher
Inside door handle escutcheon
Main power window and door lock/
unlock switch finisher
Door mirror corner finisher
Grommet
Clip
Pawl
Front
NOTE:
LH side shown; RH similar.
Removal and Installation
CAUTION:
When ...
System
System Description
System Description
SYSTEM DIAGRAM
AV Control Unit Input Signal (CAN
Communication)
Transmit unit
Signal name
ABS actuator and e ...
I-FCW system limitations
Illustration A
WARNING
Listed below are the system limitations for the Intelligent Forward Collision
Warning (I-FCW) system. Failure to operate the Nissan Sentra in accordance with
these system limitations could result in serious injury or death.
The I-FCW system on the Nissan Sentra c ...