Dtc Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|
P10C1 |
Internal control module fuel injector (Internal control module fuel injector) |
Diagnosis condition |
Battery voltage: 11 V or more |
|
Signal (terminal) |
— |
||
|
Threshold |
Direct injector driver unit is malfunctioning. |
||
|
Diagnosis delay time |
— |
||
POSSIBLE CAUSE
Harness or connectors
Direct fuel injector circuit is open
Battery power supply
ECM (Direct injector driver unit)
FAIL-SAFE
Engine Control System
|
Engine operating condition in fail-safe mode |
||
|---|---|---|
|
Fail safe mode |
Nissan Sentra Vehicle behavior |
|
|
Traveling control mode |
Accelerator angle variation control |
ECM controls the accelerator pedal depression speed to make it slower than actual speed. This causes a drop in accelerating performance and encourages the driver to repair malfunction. Note:
ECM does not control the accelerator pedal releasing speed. |
|
Device fix mode |
|
|
|
Combustion control mode |
Stratified charge combustion control at starting |
No stratified charge combustion at starting (cold start). |
Idle Start/Stop System
When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited.
When ECM detects error while operating the idle start/stop system, ECM restarts the engine.
Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 12 - 15 V at idle.
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
Start engine and let it idle for at least 10 seconds.
Check 1st trip DTC.
Is 1st trip DTC detected?
YES >>Refer to DTC Diagnosis Procedure.
NO-1 >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>Confirmation after repair: INSPECTION END
Dtc Diagnosis Procedure
CHECK DIRECT FUEL INJECTOR
Check direct fuel injector. Refer to Component Function Check.
Is inspection result normal?
YES >>GO TO 2.
NO >>Repair or replace error-detected parts.
PERFORM DTC CONFIRMATION PROCEDURE
Turn ignition switch ON.
Erase DTC.
Perform DTC confirmation procedure again. Refer to Component Function Check.
Check 1st trip DTC.
Is the DTC displayed again?
YES >>Replace ECM. Refer to ECM : Removal & Installation.
NO >>INSPECTION END
P10c0 Internal Control Module Fuel Injector
P10c2 Internal Control Module Fuel InjectorIntelligent Key
Consult Function (bcm - Intelligent Key)
CONSULT Function (BCM - INTELLIGENT KEY)
BCM
Refer to CONSULT Function (BCM - INTELLIGENT
KEY).
...
Component Function Check
Component Function
Check
CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION
OPERATION
Check that the push-button ignition switch illumination
turns ON/OFF in all of the conditions. Refer to System Description.
Is the i ...
Rear disc brake
Exploded View
Sliding pin bolt
Bushing
Cap
Bleeder valve
Cylinder body
Piston seal
Piston
Piston boot
Sliding pin boot
Torque member
Apply rubber grease
Apply brake fluid
Disassembly and Assembly
DISASSEMBLY
Place a wooden block as shown, and blow air from union ...