Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Normal Operating Condition

Description

Description

Note:

For Telematics system operation detail information, refer to Navigation system Owner's Manual.

Symptom

Possible cause

Possible solution

The system cannot connect to the NissanConnect Data Center.

A subscription for the NissanConnect service has not been established.

Sign up for a subscription to the NissanConnect service. For details about subscriptions, contact an NISSAN dealer or visit the NissanConnect Data Center website.

The user ID and password are not entered.

Enter the user ID and password.

The communication line is busy.

Try again after a short period of time.

The Nissan Sentra vehicle is in a location where reception is difficult.

When the Nissan Sentra vehicle moves to an area where radio waves can be transmitted sufficiently, communication will be restored. When the icon on the display shows that the Nissan Sentra vehicle is inside the communication area, the system can be used.

TCU reception is insufficient.

When the Nissan Sentra vehicle moves to an area where radio waves can be transmitted sufficiently, communication will be restored. When the icon on the display shows that the Nissan Sentra vehicle is inside the communication area, the system can be used.

Some of the items that are displayed on the menu screen cannot be selected.

The Nissan Sentra vehicle is being driven and some menu items are disabled.

The Nissan Sentra vehicle is being driven. Stop the vehicle in a safe location and apply the parking brake before operating the functions.

Some parts of the screen are not displayed

Operate the system after stopping the Nissan Sentra vehicle in a safe location and applying the parking brake.

The system does not announce information.

The volume level is set to the minimum.

Adjust the volume level by operating the VOL switches located on the control panel or on the steering switch while the system is announcing information.

Telematics System
Symptom Table Symptom Table TELEMATICS SYSTEM Symptom Display icon ...

Removal and Installation
...

Other materials:

P27eb-00 Transmission Range Control a Position Sensor/switch
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection ...

Dtc Diagnosis Procedure
DTC Diagnosis Procedure Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported ...

P2a01 O2 Sensor 2 Bank 1
Dtc Description DTC Description The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. MALFUNCTION A To judge the ...

© 2014-2026 Copyright www.nisentra.com