Nissan Sentra B18 (2020-2025) Service Manual: Inspection (rh)
INSPECTION AFTER REMOVAL
Check the following items and replace the part if necessary.
-
Move the joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for significant looseness.
-
Check the boot for cracks, damage, and grease leaks.
-
Check the support bearing bracket (if equipped) for cracks, deformation, and other damage.
INSPECTION AFTER INSTALLATION
Check the wheel sensor harness to be sure the connectors are fully seated.
Check the wheel alignment. Refer to Inspection.
Removal and Installation (rh)
Removal and
Installation (RH)
Note:
When removing components such as hoses, tubes,
lines, etc., cap or plug openings to prevent fluid from spilling.
REMOVAL
For M/T models, drain the ...
Other materials:
License Plate Lamp
Component Inspection
Component Inspection
CHECK LICENSE PLATE LAMP 1
Ignition switch OFF.
Disconnect license plate lamp connector.
Check continuity b ...
Precaution for Liquid Gasket
Removal of liquid gasket
After removing the bolts and nuts, separate the mating surface and
remove the old liquid gasket using tool.
Tool number : kv10111100 (j-37228)
Caution:
Do not damage the mating surfaces.
Tap the seal cutter to insert it (1).
In areas where the tool is diffic ...
Passenger Side
Exploded View
Exploded View
1.
Headrest
2.
Headrest holder (locked)
3.
...
