S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: Inspection (lh)

Inspection (LH)

INSPECTION AFTER REMOVAL

Check the following items and replace the part if necessary.

  • Move the joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for significant looseness.

  • Check the boot for cracks, damage, and grease leaks.

INSPECTION AFTER DISASSEMBLY

Check the following items and replace the part if necessary.

Shaft

Check the shaft for runout, cracks, or other damage. Replace the entire drive shaft if necessary.

Dynamic Damper

Check the dynamic damper for cracks or wear. Replace the entire drive shaft if necessary.

Joint Sub-Assembly

Check the following:

  • Joint sub-assembly for rough rotation and excessive axial looseness.

  • The inside of the joint sub-assembly for entry of foreign material.

  • Joint sub-assembly for compression scars, cracks, and fractures inside of the joint sub-assembly.

Replace the entire drive shaft if there are any non-standard conditions of components.

Housing and spider assembly

Replace the entire drive shaft if there is scratching or wear of the housing roller contact surface or the spider roller contact surface.

INSPECTION AFTER INSTALLATION

Check the wheel sensor harness to be sure the connectors are fully seated.

Check the wheel alignment. Refer to Inspection.

    Removal and Installation (lh)
    Removal and Installation (LH) Note: When removing components such as hoses, tubes, lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL For M/T models, drai...
    Exploded View
    Exploded View RH 1. Front drive shaft 2. Bearing retainer 3. Support bearing bracket A. Support bearing bracket (CVT) B. Support bearing bracket (MT) C. Refer to Installation.

    Other materials:

    Ecu Diagnosis Information
    A/c Auto Amp. Values on the Diagnosis Tool Values on the Diagnosis Tool Note: The following table includes information (items) inapplicable to this Nissan Sentra vehicle: For information (items) applicable to this vehicle, refer to CONSULT display items. ...

    P0506 Isc System
    Dtc Description DTC Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for ...

    Roof. Basic Inspection
    Diagnosis and Repair Work Flow. Work Flow Work Flow Work Flow OVERALL SEQUENCE DETAILED FLOW INTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfuncti ...