Nissan Sentra Owners Manual: In case of emergency
- Emergency engine shut off (Push-button ignition models only)
- Hazard warning flasher switch
- Flat tire
- Jump starting
- Push starting
- If your vehicle overheats
- Towing your vehicle
Engine block heater (if so equipped)
Engine block heaters are used to assist with cold
temperature starting.
The engine block heater should be used when
the outside temperature is 20°F (-7°C) or lower.
WARNING
Do not u ...
Emergency engine shut off (Push-button ignition models only)
To shut off the engine in an emergency situation
while driving, perform the following procedure:
Rapidly push the push-button ignition switch 3
consecutive times in less than 1.5 seconds, or
...
Other materials:
P0182, P0183 FTT Sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0182
FTT SEN/CIRCUIT
(Fuel temperature sensor
″A″ circuit low)
An excessively low voltage from the sensor is
sent to ...
Rear power window switch
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the rear power window
switch and finisher as an assembly
and remove
Disconnect the harness connector from the rear power window switch.
Release the pawl (one on each side) using a suitable tool, then
se ...
Electrical load signal
Description
The electrical load signal (Headlamp switch signal, rear window defogger
switch signal, etc.) is transferred via
the CAN communication line.
Component Function Check
1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION
With CONSULT
Turn ignition switch ON.
Select “DATA MONITORР...
