Bulb Replacement
Removal and InstallationCan communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on can communication system.
Check terminals and connectors for damage, bend and loose connection.
Is the inspection resu ...
Generic Squeak and Rattle Troubleshooting
Generic Squeak and Rattle Troubleshooting
Refer to Table of Contents for specific component
removal and installation information.
INSTRUMENT PANEL
Most incidents are caused by contact and movement
between:
Cluster lid A and the instrument panel
Acrylic len ...
Disposal
Disposal
Set the
shock absorber horizontally with the piston rod fully
extended.
Drill a 2
– 3 mm (0.08 – 0.12 in) hole at the position ()
from the top as shown to release gas gradually.
CAUTION:
Wear eye protection (safety glasses).
...