Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Headlamp (hi) Circuit

Component Function Check

Component Function Check
  1. CHECK HEADLAMP (HI) OPERATION

    1. CONSULT

      1. Select “HEADLAMP (HI)” in “Active Test” mode of “IPDM E/R”.

      2. Turn lighting switch 2ND.

      3. With operating the test item, check that the headlamp (HI) is turned ON.

        On

        : Headlamp (HI) ON

        Off

        : Headlamp (HI) OFF

    Is the inspection result normal?

    YES>>

    Headlamp (HI) circuit is normal.

    NO>>

    Refer to Diagnosis Procedure.

Diagnosis Procedure

Diagnosis Procedure
  1. CHECK HEADLAMP (HI) OUTPUT VOLTAGE

    1. CONSULT

      1. Ignition switch ON.

      2. Turn lighting switch 2ND.

      3. Select “HEADLAMP (HI)” in “Active Test” mode of “IPDM E/R”.

      4. With operating the test item, check voltage between IPDM E/R harness connector and ground.

        +

        -

        Test item

        Voltage

        (Approx.)

        IPDM E/R

        Connector

        Terminal

        RH

        E48

        54

        Ground

        HEADLAMP (HI)

        On

        Battery voltage

        Off

        0V

        LH

        E44

        59

        On

        Battery voltage

        Off

        0V

    Is the inspection result normal?

    YES >>

    GO TO 2.

    NO >>

    GO TO 3.

  2. CHECK HEADLAMP (HI) POWER SUPPLY CIRCUIT (OPEN)

      1. Ignition switch OFF.

      2. Turn lighting switch OFF.

      3. Disconnect IPDM E/R connector and front combination lamp connector.

      4. Check continuity between IPDM E/R harness connector and front combination lamp harness connector.

        IPDM E/R

        Front combination lamp

        Continuity

        Connector

        Terminal

        Connector

        Terminal

        RH

        E48

        54

        E38

        8

        Yes

        LH

        E44

        59

        E37

    Is the inspection result normal?

    YES>>

    Refer to Diagnosis Procedure.

    NO>>

    Repair or replace harness.

  3. CHECK HEADLAMP (HI) POWER SUPPLY CIRCUIT (SHORT TO GROUND)

      1. Ignition switch OFF.

      2. Turn lighting switch OFF.

      3. Disconnect IPDM E/R connector, front combination lamp RH connector and front combination lamp LH connector.

      4. Check continuity between IPDM E/R harness connector and ground.

      IPDM E/R

      Continuity

      Connector

      Terminal

      RH

      E48

      54

      Ground

      No

      LH

      E44

      59

    Is the inspection result normal?

    YES >>

    Replace IPDM E/R. Refer to Removal and Installation.

    NO >>

    Repair or replace harness.

Other materials:

NISSAN Intelligent Key
WARNING Radio waves may adversely affect electronic medical equipment. Drivers or passengers who use a pacemaker or similar medical device should consult the device manufacturer regarding possible effects before using the NISSAN Intelligent Key in the Nissan Sentra. The Intelligent Ke ...

NISSAN Advanced Air Bag System (front seats)
Top tether anchor Rear seat belts Roof-mounted curtain side-impact and rollover supplemental air bag Head restraints/headrests Front seat belts Pressure sensors in door (driver's side shown; front passenger side similar) Supplemental front-impact air bags Front crash zone se ...

Jump starting
To start the engine of your Nissan Sentra using a booster (jump) battery, all instructions and safety precautions listed below must be followed carefully. Incorrect procedures may cause damage to the electrical system or result in serious injury. WARNING If performed incorrectly, jump start ...

© 2014-2026 Copyright www.nisentra.com