Nissan Sentra B18 (2020-2025) Service Manual: B2a04 Calibration
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|---|---|---|---|
|
B2A04-51 |
Calibration (Around view monitor control unit) |
Diagnosis condition |
Ignition switch ON |
|
Signal (terminal) |
— |
||
|
Threshold |
Calibration is incomplete or the connected camera is different from the one when calibrated. |
||
|
Diagnosis delay time |
2 seconds or more |
||
POSSIBLE CAUSE
Camera calibration
FAIL-SAFE
-
Unmatched icon
display (red) is displayed (applicable
for unmatched camera only). -
MOD (Moving Object Detection) function is stopped.
Confirmation Procedure
Confirmation Procedure
-
PERFORM DTC CONFIRMATION PROCEDURE
-
CONSULT-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “AVM”.
-
Check DTC.
-
Is DTC B2A04–51 detected?
YES >>Proceed to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
PERFORM CALIBRATING CAMERA IMAGE
-
When DTC B2A04–51 is detected, perform camera calibration.
Perform camera calibration. Refer to Work Procedure.
-
Other materials:
P2808-00 Pressure Control Solenoid G
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
conditi ...
B24f5-93 Mode Door Motor
Dtc Description
DTC Description
DTC DETECTION LOGIC
Note:
If all of door motors DTC (B24F5-93, B24F6-93,
B24F7-93, B24F8-93) are detected, check “DOOR MOTOR CIRCUIT”. Refer
to Diagnosis Procedure.
DTC No.
...
U1231 Amplifier Temperature
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection condition
...