Nissan Sentra B18 (2020-2025) Service Manual: Front Door Lock
Exploded View
Exploded View
|
1 . |
Outside handle |
2. |
Door lock cylinder (LH only) |
3. |
Rear gasket |
|
4. |
Outside handle bracket |
5. |
Door key cylinder rod (LH only) |
6. |
Front door lock |
|
7. |
Inside handle escutcheon |
8. |
Inside handle |
9. |
Front gasket |
![]() |
Pawl |
A. |
Clip |
B. |
Clip |
Door Lock
Removal and Installation
Removal and Installation
REMOVAL
Remove outside handle. Refer to Removal and Installation.
Remove bolts and front door rear run. Refer to Exploded View.
Remove door lock bolts and remove front door lock.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Do not reuse front door lock bolts.
-
After installation, check door lock cables are properly engaged to inside handle and outside handle bracket.
-
When installing door key cylinder rod (LH only), be sure to rotate door key cylinder rod holder until a click is felt.
-
After installation, check door open/close and lock/unlock operation.
Inside Handle
Removal and Installation
Removal and Installation
REMOVAL
Remove front door finisher. Refer to Removal and Installation.
Remove screws and door inside handle.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
After installation, check door lock cables are properly engaged to inside handle.
-
After installation, check door open/close and lock/unlock operation.
Outside Handle
Removal and Installation
Removal and Installation
REMOVAL
Fully close front door glass.
Remove front door finisher. Refer to Removal and Installation.
Disconnect the harness connector from the outside mirror.
Disconnect the harness connector from the blind spot warning (if equipped).
Disconnect the harness connector from the speaker.
Disconnect the harness connector from the front door lock.
Release the front door harness clip.
Remove front door vapor barrier.
Disconnect the harness connector from the outside handle.
Release pawls and release harness connector from outside handle bracket.
Separate door key cylinder rod [LH
only (1)] from door key cylinder assembly [LH only (2)].
Remove door side grommet (1), and
loosen door lock bolt (2) in grommet hole.
While pulling outside handle, remove
door key cylinder assembly (LH side) or outside handle escutcheon
(RH side) as shown.
While pulling outside handle (1),
slide toward rear of Nissan Sentra vehicle to remove outside handle as shown.
Remove front gasket (1) and rear
gasket (2) as shown.
|
|
:Pawl |
|
|
:Front |
Slide outside handle bracket toward
rear of Nissan Sentra vehicle to remove as shown.
|
|
:Front |
Disconnect outside handle cable
(1) from outside handle bracket (2) in the sequence shown.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
When installing door key cylinder rod (LH only), be sure to rotate door key cylinder rod holder until a click is felt.
-
After installation, check door lock cable is properly engaged to outside handle bracket.
-
After installation, check door open/close and lock/unlock operation.
Other materials:
Squeak and Rattle Trouble Diagnoses
Work Flow
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine
the conditions that exist when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions
when the noise occurs and any customer's comments; refer ...
Unit Removal and Installation. Transaxle Assembly
Transaxle Assembly
Exploded View
Exploded View
1.
CVT fluid charging pipe cap
2.
CVT fluid charging pipe
...
Driver Side
Exploded View
Exploded View
POWER SEAT
1.
Seatback trim
2.
Seatback pad
3.
...

