Nissan Sentra manuals

Nissan Sentra Service Manual: Ecm branch line circuit

Diagnosis procedure

1.Check connector

  1. Turn the ignition switch off.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the ecm for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.Check harness for open circuit

  1. Disconnect the connector of ecm.
  2. Check the resistance between the ecm harness connector terminals.

Is the measurement value within the specification?


Is the measurement value within the specification? Yes >> go to 3.

No >> repair the ecm branch line.

3.Check power supply and ground circuit

Check the power supply and the ground circuit of the ecm. Refer to ec-164, "diagnosis procedure".

Is the inspection result normal? Yes (present error)>>replace the ecm. Refer to ec-485, "removal and installation".

Yes (past error)>>error was detected in the ecm branch line.

No >> repair the power supply and the ground circuit.

Main line between ipdm-e and dlc circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and ...

Abs branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electri ...

Other materials:

Brake fluid
Inspection BRAKE FLUID LEVEL Make sure that the brake fluid level in the reservoir tank is between the MAX and MIN lines. Visually check around the reservoir tank for brake fluid leakage. If the brake fluid level is excessively low, check the brake system for leakage. If brake warning ...

U1010 Control unit (CAN)
Description Initial diagnosis of ABS actuator and electric unit (control unit) DTC Logic DTC DETECTION LOGIC DTC Items (CONSULT screen terms) DTC detection condition Possible cause U1010 CONTROL UNIT (CAN) When detecting error during the initial diagnosis ...

Passenger compartment
CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not operate, check for an open fuse. NOTE: The fuse box is located on the driver’s side of the ...

© 2014-2025 Copyright www.nisentra.com