Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. PERFORM SELF DIAGNOSTIC RESULT

    1. CONSULT

      1. Ignition switch ON.

      2. Select "Self Diagnostic Result" mode of “IPDM E/R”.

    Is any DTC detected?

    YES >>

    Check the DTC. Refer to DTC Index.

    NO >>

    GO TO 2.

  2. CHECK CONNECTOR AND TERMINAL

      1. Ignition switch OFF.

      2. Disconnect IPDM E/R harness connector.

      3. Disconnect EPS control unit harness connector.

      4. Check the connector for disconnection or looseness.

      5. Check the pin terminals for damage or loose connection with harness connector.

    Is the inspection result normal?

    YES >>

    GO TO 3.

    NO >>

    Repair or replace harness, connector, or terminal, securely lock the connector.

  3. PERFORM SELF DIAGNOSTIC RESULT

    1. CONSULT

      1. Connect IPDM E/R harness connector.

      2. Connect EPS control unit harness connector.

      3. Ignition switch ON.

      4. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".

      5. Ignition switch OFF and wait for at least 10 seconds.

      6. Ignition switch ON.

      7. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.

    Is DTC “C1629-87” detected?

    YES>>

    EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.

    NO>>

    Inspection End.

Confirmation Procedure
Confirmation Procedure PRECONDITIONING If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait ...

C1630-87 Can Comm Circuit
...

Other materials:

The parking brake release warning continues sounding, or does not  sound
Description The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released. The parking brake warning buzzer does not sound at all even though driving the vehicle with the parking brake applied. Diagnosis procedure 1.Check parking ...

Secondary Pressure Solenoid Valve Circuit
Diagnosis Procedure Diagnosis Procedure CHECK HARNESS CONNECTOR Ignition switch OFF. Check the mating condition of TCM harness connector and CVT unit harness connector. Is the inspect ...

Removal and Installation
Removal and Installation REMOVAL Disconnect the harness connector from the accelerator pedal assembly. Remove bolts and remove accelerator pedal assembly. CAUTION: Do not disassemble accelerator pedal assembly. Do not r ...

© 2014-2026 Copyright www.nisentra.com