Nissan Sentra manuals

Nissan Sentra Service Manual: The parking brake release warning continues sounding, or does not  sound

Nissan Sentra Service Manual / Driver information & multimedia / Warning chime system / Symptom diagnosis / The parking brake release warning continues sounding, or does not  sound

Description

Diagnosis procedure

1.Check parking brake warning lamp

  1. Start the engine.
  2. Check the operation of the brake warning lamp by operating the parking brake.

Is the inspection result normal?


Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".

No >> go to 2.

2.Check parking brake switch signal circuit

Check the parking brake switch signal circuit. Refer to mwi-60, "diagnosis procedure".

Is the inspection result normal? Yes >> go to 3.

No >> repair or replace harness or connector.

3.Check parking brake switch

Check the parking brake switch. Refer to mwi-61, "component inspection".

Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".

No >> replace parking brake switch. Refer to pb-7, "exploded view".

Warning chime system symptoms
Symptom table Caution: Perform the self-diagnosis with consult before the symptom diagnosis. Perform the trouble diagnosis if any dtc is detected. ...

The seat belt reminder warning continues sounding, or does not sound
Description Seat belt reminder warning does not sound. Seat belt reminder warning sounds continuously. Diagnosis procedure 1.Check seat belt warning lamp Turn ignition switch on. Chec ...

Other materials:

P0171 Fuel injection system function
DTC Logic DTC DETECTION LOGIC With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture ratio can be brought closely to the theoretical mixture ratio based on the mixture ratio feedback signal from the A/F sensors 1. The ECM calculates the necessary compensation to correct th ...

Sunshade
Exploded View Sunshade Moonroof unit assembly Sunshade stopper (LH/RH) Front Removal and Installation REMOVAL Remove the headlining. Refer to INT-40, "Removal and Installation". Remove the sunshade stoppers (1) (LH/RH) from the moonroof unit assembly side rails (2) ...

Front wiper auto stop signal circuit
Component function check 1. Check front wiper (auto stop) operation Consult data monitor Select “WIP AUTO STOP” of IPDM E/R DATA MONITOR item. Operate the front wiper. With the front wiper operation, check the monitor status. Is the inspection result normal? YES >> ...

© 2014-2025 Copyright www.nisentra.com