Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure
The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
-
Activate and display TPMS sensor IDs
-
Display tire pressure reported by the TPMS sensor
-
Read TPMS DTCs
-
Register TPMS sensor IDs
-
PERFORM SELF DIAGNOSTIC RESULT
-
CONSULTReplace rear right tire pressure sensor even if other DTCs are displayed along with “C1734-68” in "Self Diagnostic Result" mode of “BCM(AIR PRESSURE MONITOR)”.
Replace rear right tire pressure sensor. Refer to Removal and Installation.
-
Dtc Confirmation Procedure
DTC Confirmation Procedure
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Select “Self Diagnostic Result” mode
of “BCM(AIR PRESSURE MONITOR) ...
Other materials:
B2267-29 Engine Speed
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detected condition
...
Diagnosis Procedure
Diagnosis Procedure
The front wiper does not operate under any operation
conditions.
CHECK WIPER RELAY OPERATION
CONSULT
Select “FRONT WIPER” in "Active Test" mode of "IPDM
E/R".
...
Fuel Tank Temperature Sensor
Component Inspection
Component Inspection
CHECK FUEL TANK TEMPERATURE (FTT)
SENSOR
Turn ignition switch OFF.
Disconnect fuel level sensor unit and
fuel pump harness connector.
Remov ...
