S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: C1741-21 Tire Pressure Sensor No Data Fl

Dtc Description

DTC Description

Note:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

C1741-21

Tire pressure sensor no data FL

(Tire pressure sensor no data front left)

Diagnosis condition

Drive at a speed of 25 MPH (40 km/h) or more reaches 10 minutes in total.

Signal (terminal)

Tire pressure sensor signal.

Threshold

Tire pressure data signal from the front left tire pressure sensor cannot be detected.

Diagnosis delay time

10 minutes or more.

POSSIBLE CAUSE

  • Driving in area with radio interference

  • Front left tire pressure sensor ID registration incomplete

  • Front left tire pressure sensor

  • Harness or connectors

  • BCM

FAIL-SAFE

—

Dtc Confirmation Procedure

DTC Confirmation Procedure

  1. TIRE PRESSURE SENSOR ID REGISTRATION

    1. Perform tire pressure sensor ID registration. Refer to Work Procedure.

    >>

    GO TO 2.

  2. PERFORM DTC CONFIRMATION

    1. CONSULT

      1. Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more reaches 10 minuets in total.

        Note:

        Avoid driving in areas with radio interference.

      2. Stop the Nissan Sentra vehicle.

      3. Select “Self Diagnostic Result” mode of “BCM(AIR PRESSURE MONITOR)”.

    Is DTC “C1741-21” detected?

    YES>>

    Refer to DTC Diagnosis Description.

    NO>>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO>>

    Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

Note:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

  1. CHECK TIRE PRESSURE SIGNAL

    1. CONSULT

      1. Select "AIR PRESS FL" in "Data Monitor" mode of "BCM(AIR PRESSURE MONITOR)".

      2. Check that the front left tire pressures match the standard value. Refer to Values on the Diagnosis Tool.

        Note:

        BCM holds last tire pressure values during 17 minutes after ignition switch is OFF.

    Are all tire pressures displayed 0 kPa (psi)?

    YES>>

    GO TO 2.

    NO>>

    GO TO 3.

  2. CHECK BCM POWER SUPPLY CIRCUIT

    1. Check BCM power supply circuit. Refer to Diagnosis Procedure.

    Is the inspection result normal?

    YES>>

    GO TO 3.

    NO>>

    Repair or replace harness or connectors.

  3. TIRE PRESSURE SENSOR ID REGISTRATION

    1. Perform tire pressure sensor ID registration. Refer to Work Procedure.

    Can the tire pressure sensor ID registration be completed?

    YES>>

    GO TO 4.

    NO>>

    Replace applicable front left tire pressure sensor. Refer to Removal and Installation.

  4. RECHECK TIRE PRESSURE SIGNAL

    1. CONSULT

      1. Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more reaches 10 minuets in total.

        Note:

        Avoid driving in areas with radio interference.

      2. Stop the Nissan Sentra vehicle.

      3. Select "AIR PRESS FL" in "Data Monitor" mode of "BCM(AIR PRESSURE MONITOR)".

      4. Check that the front left tire pressures match the standard value. Refer to Values on the Diagnosis Tool.

    Is the inspection result normal?

    YES>>

    After erasing DTC record, Inspection End.

    NO>>

    Replace BCM. Refer to Removal and Installation.

    C1734-68 Tire Pressure Sensor Rr
    Dtc Description DTC Description Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additio...
    C1742-21 Tire Pressure Sensor No Data Fr
    Dtc Description DTC Description Note: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additio...

    Other materials:

    Knock Sensor
    Component Inspection Component Inspection CHECK KNOCK SENSOR Turn ignition switch OFF. Disconnect knock sensor harness connector. Check resistance between knock sensor terminals ...

    Warning/Indicator lights (other)
    For additional details about warning and indicator functions in the Nissan Sentra, refer to the sections titled "Vehicle information display 4.2 inch (11 cm) Type A" or "Vehicle information display 7 inch (18 cm) Type B", depending on the equipment installed in your vehicle ...

    Multi Av System
    Symptom Table Symptom Table RELATED TO AUDIO Symptoms Check items Probable malfunction location No sound comes ...