Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Diagnosis Procedure

Diagnosis Procedure

The front wiper does not operate under any operation conditions.

  1. CHECK WIPER RELAY OPERATION

    1. CONSULT

      1. Select “FRONT WIPER” in "Active Test" mode of "IPDM E/R".

      2. With operating the test item, check front wiper operation.

        Low

        : Front wiper (LO) operation

        High

        : Front wiper (HI) operation

        Off

        : Stop the front wiper

    Is front wiper operation normally?

    YES >>

    GO TO 4.

    NO >>

    GO TO 2.

  2. CHECK FRONT WIPER MOTOR FUSE

      1. Ignition switch OFF.

      2. Check that the following fuse is not blown (open):

      Unit

      Location

      Fuse No.

      Capacity

      Front wiper motor

      IPDM E/R

      85

      30 A

    Is the fuse blown (open)?

    YES >>

    Replace the blown fuse after repairing the affected circuit.

    NO >>

    GO TO 3.

  3. CHECK FRONT WIPER MOTOR GROUND CIRCUIT

    1. Check front wiper motor ground circuit. Refer to Diagnosis Procedure.

    Is the inspection result normal?

    YES >>

    Replace front wiper motor. Refer to Removal and Installation.

    NO >>

    Repair or replace harness.

  4. CHECK FRONT WIPER REQUEST SIGNAL INPUT

    1. CONSULT

      1. Select “Front wiper” in "Data Monitor" mode of “IPDM E/R”.

      2. Switch the front wiper switch to HI and LO.

      3. With operating the front wiper switch, check the status of “FRONT WIPER”.

        Monitor item

        Condition

        Monitor status

        Front wiper

        Front wiper switch

        HI

        High

        LO

        Low

        INT

        OFF

        Stop

    Is the inspection result normal?

    YES >>

    Replace IPDM E/R. Refer to Removal and Installation.

    NO >>

    GO TO 5.

  5. CHECK COMBINATION SWITCH (WIPER AND WASHER SWITCH)

    1. Perform the inspection of the combination switch (wiper and washer switch). Refer to Symptom Table.

    Is combination switch (wiper and washer switch) normal?

    YES>>

    Replace BCM. Refer to Removal and Installation.

    NO>>

    Replace combination switch (wiper and washer switch). Refer to Removal and Installation.

Front Wiper Does Not Operate
...

Normal Operating Condition
...

Other materials:

Abs Actuator and Electric Unit (control Unit)
Exploded View Exploded View 1. ABS actuator and electric unit (control unit) 2. Insulator collar ...

U1040 Eng Comm Circuit
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

Dtc Diagnosis Procedure
DTC Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuse is not blown (open): ...

© 2014-2026 Copyright www.nisentra.com